Loading Paper - Brother MFC-5440CN Quick Setup Manual

Step 1
Removing the Protective
1
Parts
1
Remove the protective tape and paper.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.

Loading Paper

2
To load paper or other media
1
Pull the paper tray completely out of the
MFC and remove the output paper tray.
2
Press and slide the paper side guide to fit
the paper width.
Paper Side Guide
2
Setting Up the Machine
3
Pull out the paper support and unfold the
paper support flap.
Paper Support Flap
Use the paper support flap for Letter, Legal
and A4 size paper.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
5
Gently insert the paper into the paper tray
print side down and the leading edge (top of
the paper) in first.
Check that the paper is flat in the tray and
below the maximum paper mark.
■ Make sure the paper side guides touch
the sides of the paper.
■ Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
6
Put the output paper tray back on and push
the paper tray firmly back into the MFC.
Paper Support
Maximum Paper Mark