CODELOCKS CL160 Instructions page 2

Find more online at www.codelockssupport.com
6. Select and enter your new code rotating each digit clockwise using the code change tool provided (FIG 5) .
7. Press 'C' clear button followed by your new code. Rotate the lever fully (FIG 6) and the 'A' button will revert to normal position.
Note : If 'A' button does not return refer to point 5 and check the position of the indictors. If required reset all turning anti-clockwise as per FIG
3 and repeat steps.
8. If EasyCode Function is required, replace retaining screw behind 'A' button, to prevent on-door code change. For QuickCode Function
leave retaining screw out.
AFTER INSTALLATION
A. Press 'A' button. If button will not depress, remove front plate from the door and follow code change sequence from bullet points 1-7.
B. Press 'A' Button. If button will depress follow the code change sequence from bullet point 3 -6. Please ensure the door is held in the open
position until code sequence has been verified.
MAINTENANCE
No maintenance of the working parts is necessary. DO NOT OIL. To maintain the finish the lock should be cleaned regularly with a soft cloth.
A silicone spray or similar, should be used to provide a protective film against grit and grime.
GUARANTEE
If any Codelocks mechanical lock should develop a fault, at any time due to manufacturing, just call the Codelocks Helpline and arrange for it
to be repaired free of charge.
Page 2