Breakdown Into The 4 Metres Long Package - Aeros Stealth 14 KPL 2 Manual

equally taught, roll the sail up to the dive sticks and place it along the leading edge. Secure the sail
at dive stick with the velcro ties. Continue rolling the sail up to the wing tip bags and secure the
wing with more velcro straps (Fig. 16).
Fig. 16
4.1.8. Cover the rear keel tube/wires junction by a protective bag. Place the bags with battens on the
nose section along the keel, put the nose cone under the velcro strap that is nearest to the nose
tighten tape (Fig. 16). Fit the bag over the glider (from the upper side).
4.1.9. Lay the glider in the bag on the ground. Place hang loop spreader bar along the keel tube
between the uprights. Bring all wires forward along tubes and place uprights inside the folded sail.
Detach the speedbar from the uprights and place it between the leading edges in the bag provided.
4.1.10. Cover the upright junctions in the low control bar corners by the protective bag and place
them along the keel tube. Straighten the bottom wires and the spacer between the uprights. Zip the
zipper on the bag.
The glider is ready for transportation.
4.2. Breakdown into the package 4 metres long
4.2.1. Perform the procedures as described in the points 4.1.1. - 4.1.10., except the last procedure.
4.2.2. Remove the sail mount webbing from the leading edges end caps. Press the spring lock pins
through the sail and remove the tubes No.3 from the sail.
4.2.3. Place the leading edge of one sail over the other one, fold the sail to the nose and fix it with
the velcro strap to the bag.
4.2.4. Place the detached leading edges into the bag and zip the bag.
16