Still Tl Breakdown For Shipping Procedure; Still Tl Set-Up Procedure - Aeros Still TL Owner's Service Manual

Aeros convention is that red marked battens go in the left wing and green marked battens in the
right. Battens are numbered from the center outwards, and the longest batten in a Still TL is
designated as the "# 1" batten.
Figure 7 Figure 8
10. The further set up procedure is similar to the one from a 6-meter long package.

4. STILL TL BREAKDOWN FOR SHIPPING PROCEDURE

This process will basically be the reverse of reassembling after breakdown for shipping. Before
beginning, read through the section above on how to re-install the rear leading edges.

5. STILL TL SET-UP PROCEDURE

1. Lay the wing on the ground, with the bag zipper up and the nose of the wing pointing
downwind.
2. Undo zipper and take out battens, struts and the control bar (Fig. 9).
Figure 9
3. Untie the two middle Velcro straps. Turn the wing on one side and spread the down tubes.
Install the control bar according to the markings. Fix control bar using bolts, nuts and safety
rings. Check the control bar fixing nuts are pointing backwards, against the direction of flight.
7