Profi Tl Breakdown For Shipping Procedure; Profi Tl Set-Up Procedure - Aeros PROFI TL Owner's Service Manual

3.22. Install the tip lever battens.
3.23. Tension the cumbered battens by installing the lever batten tips into the hems of the
trailing edge.
3.24. Install the undersurface battens.
3.25. Deploy both the inboard sprogs and the outboard sprogs and secure them in position.
3.26. Fix the sail mount tangs at the nose part of the sail to the wing bolts (fig.18). Do not over
tighten the mount nuts. When the fixing nut is properly tightened, the sail mount tang rotate
freely on the fixing bolt.
Figure 18 Figure 19
3.27. Take the winglets and find the winglet fixing rods packed inside. Install the winglets fixing
rods to the leading edges #3 (fig. 19).
3.28. Install winglets.
3.29. While the base tube of the trike is still on the ground install the nosecone.

4. Profi TL BREAKDOWN FOR SHIPPING PROCEDURE

This process will basically be the reverse of reassembling after breakdown for shipping. Before
beginning, read through the section above. Refer to the photos in the section above for
reference, if necessary.

5. Profi TL SET-UP PROCEDURE

5.1. Lay the wing on the ground, with the bag zipper up. Lay the struts and the winglets next to
the wing.
5.2. Undo the bag zipper and take out battens and the control bar.
5.3. Untie Velcro straps. Open the control frame apex protection bag (fig. 20).
11