Fox13-T Breakdown For Shipping Procedure - Aeros NANOLIGHT TRIKE FOX13-T 2020 Owner's Service Manual

NOTE
The sail mount screws on the front part of the leading edge tubes # 1 must be unscrewed, otherwise the
excess sail tension will not allow tightening the sail.
The sail mount screws have to be screwed back after you accomplish all steps in section "Fox13-T set-up
procedure" from item 1 through item 10.
NOTE
When spreading the wings with the sail mount screws having been unscrewed check that the sail mount
webbing is in proper position in the slot of the end cap of the leading edge # 3.
6. Install the wing tip bags.
Put battens on top of the wing between Mylar pockets in the front part of the wing.
Place Velcro ties around the wing.
Put the speed bar between leading edges in the rear part of the wing.
Put the wing bag back on and zip it up.

3. FOX13-T BREAKDOWN FOR SHIPPING PROCEDURE

This process will basically be the reverse of reassembling after breakdown for shipping. Before beginning,
read through the section above on how to re-install the rear leading edges.
1. Lay the wing on the ground or floor, unzip the bag and remove the Velcro ties. Remove the speed bar
and battens from the wing. Remove the protection wing tip bags.
2. Unscrew the sail mount screws from the leading edges # 1.
3. Undo the sail mount webbing Velcro and remove the sail mount webbing from the leading edges end
caps. With the outboard sprog folded towards the nose pull the rear leading edge straight aft and slide it
backwards carefully out of the sail. Tape or pad the exposed ends of the inner leading edge tubes # 3,
and do the same for the outer leading edge tubes # 2 in order to prevent sail damage during
transportation.
4. Check to see that the leading edges are marked "Left" and "Right". If they are not, mark them with an
indelible marker.
5. Carefully fold the outermost area of the sail over onto the innermost area of the sail, place Velcro ties
around the wing and put on the wing bag, turning the bag 180 deg (i.e. matching the front part of the bag
to the rear part of the wing).
6. Zip up the wing bag zipper.
4. Tighten the sail along the leading edge by
putting the sail mount webbing into the slot in the
end cap of the leading edge # 3. (fig. 1).
5. Secure the sail mount webbing to the leading
edge tube # 3 with the sail mount webbing Velcro.
Figure 1
6