Section 2. Set Up Procedure; Set Up Procedure From The Package 4 Meters Long - Aeros Stranger & Stream Manual

Section 2. SET UP PROCEDURE

2.1. SET UP PROCEDURE FROM THE PACKAGE 4 METRES LONG
Having used the specific techniques described in this manual you will perform the set up and
break down procedures without any difficulties.
However, the following procedural descriptions are not intended to be a substitute for the
familiarization procedure of your dealer at the time the wing is delivered.
The set up procedure should be carried out on a clean, not abrasive surface. Before performing
the set up procedure you must place the glider nose to the wind. During this procedure you
must make a preflight inspection of the wing.
2.1.1. With the glider in the bag (4 metres long) lay the glider on the ground.
2.1.2. Undo the zipper. Untie the velcro straps. Remove the battens in the bags, the framebar,
the leading edge tubes N3 and the nose cone from the bag. (Fig.1)
Fig.1
2.1.3. Turn the glider so that the downtubes packed into the safety bags are on the bottom and
kingpost is on the top.
2.1.4. Unfold the sail along the leading edge. Attach the leading edge tubes N3 to the leading
edge tubes N2 according to the marking (L-left, R-right, marks must be on the top).
Fig.2
NOTE: While installing the leading edge tubes into the sail place the washout struts facing
forward toward the nose of the wing and along the leading edge tubes (Fig.2)
3