Aeros Stealth 14 KPL 2 Manual page 11

2.2.6. Attach plastic wingtips. Put front part of wingtip under sail leading edge on the front part of
tube. Put wingtip tightly to inside sail, fix it by velcro.
2.2.7. Check the trailing edge for any cuts, tears or broken stitching. Check that the battens are
properly held in place.
2.2.8. Check the rear wires/keel tube junction. Assembly must be connected with the pin and the
safety ring (Fig. 11).
2.2.9. Check that X-bar tensioning wire is secured on the hook on the keel tube. Check the proper
alignment of the VG ropes - they must not be twisted.
2.2.10. Check the following items through the main undersurface zipper:
- X-beam wire/X-beam junction;
- VG blocks/X-beam junction.
The X-beam wire and VG ropes must not be twisted (Fig. 12). Check the ropes for wear, especially
near the rollers. Zip the zipper of the bottom surface closed.
Fig. 10
Fig. 11
10