Table of Contents
Advertisement
2.2.3. Check that the leading edge mylars inserts have no bends.
2.2.4. Look through the open bottom surface pockets near the X-beam/LE junction and check that
this junction is assembled properly and safely secured with the nut and the safety ring (Fig. 9). Zip
the zipper near the X-beam/LE junction closed.
2.2.5. Look into the sail at each wing tip. Tip battens must be rested on the batten stop. The washout
tip must be installed. Check for any evidence of dents, deep scratches, cracks or bends in the LE
tubes. Be sure that the sail mount webbing is safely and correctly secured in the end cap slot (Fig.
10). Check for symmetric tension of the sail.
Fig. 8
Fig. 9
9
Advertisement
Table of Contents
