Mitsubishi Electric M Series Manual page 50

4
1. CONTROLS
5
1-4. System Control Interface [MAC-333IF-E], cont.
2. Function and electric wiring of interface each part
Indoor unit
To CN105
Function setting switch A
*Refer to section 3 "Dip
Switch Details" for details.
Function setting switch B
*Refer to section 3 "Dip
Switch Details" for details.
LED for checking communica-
tions with connected equipment
*Refer to section 12 "Interface
status monitor" for details.
Due to continuing improvement, above specification may be subject to change without notice.
50
3
2
Fig. 2-2
2
3
Fig. 2-3
To use centralized control by
M-NET
MELANS system controller
M-Net1
M-Net2
B2 A2 B1 A1
TB520
ON
SW500
1 2 3 4 5 6 7 8
ON
SW502
1 2 3 4 5 6 7 8
(Orange)(Red)
0 0
SW501 SW510
M-Net
Refrigerant address setting switch
M-NET address setting switch
*Refer to section 8 "Connecting with
*Refer to section 7 "Connecting
with M-NET system" for details. MA remote controller" for details.
M-Series - Controls (December 2016)
1 System controller, etc
2 SYSTEM CONTROL
Interface
3 Indoor Unit
4 MA remote controller
5 Contract point
To use MA remote controller
MA remote controller
TB521 TB580 MA TB571
B A R2 R1 C
S
(Gray)
(Orange)
CN560
(White)
0
MA
SW580
Fig. 2-4
6 Relay
7 Coil
8 Power supply unit for
M-NET transmission line
9 External power supply
for DC12V
Status of room air
conditioner output
Relay items, such as
heater and humidifier, etc.
connected to the relay.
DC power
supply (12V)
TB530
- +
LED for checking communica-
tions with connected equipment
(Sky Blue)
*Refer to section 12 "Interface
status monitor" for details.
CN591
(White)
Card key, Coin timer, etc.
To input control signal
and control room air
conditioner remotely
© 2016 Mitsubishi Electric US, Inc.