Mitsubishi Electric M Series Manual page 10

1. CONTROLS
WT07894X01_GB_A5.book 7 ページ ２０１５年７月７日 火曜日 午後３時３５分
1-2. Wired Remote Controller [PAR-32MAA-J], cont.
5 Install the bottom case.
■ Installation using a switch box
• Secure at least two corners of the switch box with screws.
■ Direct wall installation
• Thread the cable through the groove.
• Secure at least two corners of the remote controller with screws.
• Be sure to secure top-left and bottom-right corners of the remote controller (viewed from the front) to prevent it from lifting.
(Use molly anchor etc.)
■ Installation using a switch box
Double switch box
Roundhead cross
slot screws
Important
To avoid damage to the controller, do not overtighten the screws.
6 Cut out the cable access hole.
■ Direct wall installation (when running the cable along the wall)
• Insert a flat-tip screwdriver with a blade width of 4–7 mm (5/32–9/32 inch) or a
Plate service tool into either of the two latches at the bottom of the remote
controller, and move it in the direction of the arrow as shown in the figure at
right.
• The top case will come loose from the front cover. Pull the top case toward
you to remove it.
• Cut out the thin-wall part on the front cover (indicated with the shaded area in
the right figure) with a nipper.
(This cutout hole will be used to thread the remote controller cable through,
after the cable is threaded through the groove on the back of the bottom case.)
• Place the top case onto the front cover.
Notice
To prevent damage to the circuit board, remove the front cover from
the top case before cutting out a cable access hole.
7 Route the wire to the top case.
Connect the connector on the bottom case to the connector on the top case.
Securely connect the
connectors.
Important
To prevent malfunctions, do not remove the protective film or the
circuit board from the casing.
Due to continuing improvement, above specification may be subject to change without notice.
10
Seal the cable access
hole with putty.
Refer to 2.
Remote controller
cable
M-Series - Controls (December 2016)
■ Direct wall installation
Wood
screw
Refer to 4.
To avoid damage to the controller, do not make holes on the controller
cover.
To prevent cable breakage and malfunctions, do not hang the top
controller casing hang by the cable.
Remote controller
cable
Refer to 4.
Thread the cable
through the groove.
or
Plate service tool
Top case
Front cover
© 2016 Mitsubishi Electric US, Inc.
Protection
Sheet