Mitsubishi Electric M Series Manual page 70

1. CONTROLS
1-5. Wireless Adapter [PAC-WHS01WF-E], cont.
SW1-3/4: The indoor unit fan speed can be adjusted via the following settings:
SW1-3
OFF
ON
OFF
ON
Note: Custom Auto provides more comfortable fan speed operation vs. the more
Two-Stage Thermostat Operation
SW2-6: Adjusts indoor unit operation during stage 1 heating and stage 1 cooling
according to the following table:
SW2-6
OFF
ON
Note: When either Y2 or W2 is left unconnected, it is recommended to
set SW2-6 to the OFF position. When both Y2 and W2 are connected, it is
recommended to set SW2-6 to the ON position.
Static Pressure Settings
SW2-1, SW2-2, SW2-3: These adjust the static pressure function settings of the
indoor unit according to the following table:
DIP switch position on
PAC-US444CN-1
SW2-1 SW2-2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
*Refer to the appropriate Indoor Unit Installation Manual for Mode 8 and Mode 10
Due to continuing improvement, above specification may be subject to change without notice.
70
SW1-4
OFF
OFF
ON
ON
Operation during stage 1
Full capacity
The capacity is adjusted so that the room temperature is
Indoor Unit Settings
SW2-3 Mode 8 Mode 10
OFF Not set Not set
ON Not set Not set
OFF 2 1
ON 2 2
OFF 1 1
ON 1 2
OFF 3 1
ON 3 2
M-Series - Controls (December 2016)
Result
Auto (Default)
Medium
High
Custom Auto
Mode 23 Mode 11
Not set Not set
Not set Not set
Set by SW2-4 2
Set by SW2-4 2
Set by SW2-4 2
Set by SW2-4 2
Set by SW2-4 2
Set by SW2-4 2
© 2016 Mitsubishi Electric US, Inc.