EN
Model Assembly
Landing Gear Installation
1. Install the landing gear assembly (A) on the fuselage and secure in place
using 3 screws (B).
Disassemble in reverse order.
Horizontal Stabilizer Installation
IMPORTANT: The Ultimate 3D includes two tail tubes to accommodate the
use of a 3s or 4s battery. The lightweight composite tube is recommended
to achieve correct CG when using a 3S battery. The metal tube is
recommended to achieve correct CG when using a 4S battery.
1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Secure the 2 piece horizontal tail in place with 4 pieces tape (B) included.
4. Attach the z-bend end of the elevator pushrod (C) to the outermost hole of
the servo arm.
5. Connect the ball-link end of the elevator pushrod (D) to the ball on the
elevator control horn using ball-link pliers or similar tool.
6. Ensure the elevator and rudder servo arms are in the correct position, then
adjust the linkage to center them.
Disassemble in reverse order.
8
A
E
A
R
B
3 X 10mm (3)
A
B
C
D
Ultimate 3D