Operation - Eastwood 31294 Instructions Manual

OPERATION

Disconnect air supply from the tool to prevent accidental starting and potential
injury while installing or removing Sanding Disks.
WATER CONTROL
• Fill a suitable bucket with fresh, clean, cool water, then place the Water Pickup Assembly
with the Hose attached in it.
• Water flow to the Sander is regulated by the Rotary Valve on the Water Pickup Assembly.
To increase flow; rotate knob "Clockwise" as viewed from the side. To reduce flow; rotate
knob "Counter-clockwise" as viewed from side of Water Pickup Assembly.
SANDING DISKS
• The Hook and Loop Sanding Disks are attached by pressing in place over the Hook and Loop
faced Backing Pad. They are removed by gripping the edge and pulling away from the Backing
Pad. NOTE: When replacing a Disk, be sure that the water outlet hole is aligned with the water
outlet hole in the Backing Pad.
AIR & SPEED CONTROL
• Reconnect air supply; depress the
Paddle to begin sanding action. Speed
is regulated by pressure applied to
the trigger while the Rotary Valve
located at the air inlet is used to limit
maximum speed. To increase speed
limitation; rotate knob "Clockwise"
as viewed from above (FIG 3). To
reduce speed limitation; rotate knob
"Counter-clockwise" as viewed from
top of tool body.
6
INJURY HAZARD!
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
FIG. 3
Oil Fill
Speed
Limiting
Control