Maintenance - Eastwood 21535 Instructions Manual

ABRASIVE DISK REPLACEMENT
• Unplug the Sander.
• Peel the worn Abrasive Disk away from the face of the Backing Disk.
• Peel backing paper from the replacement Abrasive Disk then carefully align the outer edge of
the replacement Disk with the edge of the Backing Disk.
The replacement Abrasive Disk must be centered on the Backing Disk or an
unbalanced condition and an unsafe condition may result.
• Press the replacement Abrasive Disk firmly in place making sure all adhesive is fully contacting
the Backing Disk.
STORAGE
• Unplug from power source.
• Wrap cord securely around Sander.
• Transport by using the built-in carry handle at the top of the motor housing.
• Store in a clean, dry, dampness free area preferably covered with plastic sheeting.

MAINTENANCE

Unplug Sander from electrical supply before performing maintenance or
making adjustments.
IMPORTANT NOTE: The following maintenance should be performed before each use:
• Check tightness of all hardware.
• Check operation and alignment of Platen Table.
• Inspect Abrasive Disk for tears, damage or premature wear.
• Clean dirt and debris from Sander motor air cooling slots.
10
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com