Optional Framing Kit - Regency Fireplace Products U900E-11 Quick Start Manual

Optional Framing kit

1. Construct the wood framing, ensure inside dimensions are 42-7/8" H x
44-3/8" W as shown below.
42-7/8"
2. Bend both side nailing strips from the side of the appliance until
positioned as shown below.
Determine the overall combined thickness of the non-combustible board
+ finished material being used. The nailing strips can be adjusted up to
1-1/2".
3. Adjust the nailing strips by loosening 2 screws on each nailing strip -
adjust and retighten screws.
4. Attach both vertical studs (466-126) to the vertical wood studs and
secure using 6 screws (2 at bottom, 2 at top and 2 on sides) as shown.
NOTE: Ensure the flat side of the steel stud is facing the wood framing.
8 | U900E-11 Gas Fireplace
919-633
OPTIONAL FRAMING KIT
44-3/8"
Nailing Strips
5. Secure horizontal steel header stud (466-128) with 2 screws per side as
per diagram.
6. Slide the unit into position. Hook up gas, venting, electrical and
conversion kit (if purchased) prior to installing the remaining steel studs.
7. Secure the upper horizontal steel stud (466-128) as shown with 2
screws per side.
8. Secure the 2 remaining large horizontal studs (466-127) with 2 screws
per side as shown.
Horizontal
stud
(466-128)
Large stud
(466-127)
Large stud
(466-127)
1
U900E
U900E-11 Gas Fireplace
(466-126)
Flat side out
Header stud
(466-128)
02.09.16