Siemens SIMATIC NET RX1500 Manual page 146

1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Configure the SIM cards. For more information, refer to the RUGGEDCOM ROX
Connecting Antennas
To connect a 3G multi-band antenna, do the following:
Configuration hazard – risk of reduced performance
Each antenna and connecting cable must have a nominal impedance of 50 Ω
with a return loss of better than 10 dB across each frequency band. If the nominal
impedance is different, Radio Frequency (RF) performance will be reduced.
RUGGEDCOM Modules
Catalog, 07/2021, C79000-G8976-1320-16
Remove the line module from the chassis. For more information, refer to the
Installation Manual for the host device.
On the smooth side of the module, remove the four screws and separate the
cover from the module housing.
1
2
3
Screw
1
Cover
2
SIM Card Cage 2
3
SIM Card Cage 1
4
Figure 6.11 SIM Card Assembly
Open Cage 1 by sliding the silver catch towards the front face of the module and
then flip the cage up.
If necessary, remove the existing SIM card.
Insert a new mini-SIM card into the cage.
Flip the cage down and slide the silver catch back to its original position.
[Optional] Repeat the steps above to install a second SIM card in Cage 2.
Place the cover on the module housing and install the four screws removed
previously.
Install the module back into the chassis. For more information, refer to the
Installation Manual for the host device.
Configuration Manual for the host device.
NOTICE
6.4 RUGGEDCOM RX1500PN LM W22
4
Cellular Modem Modules
135