Table of Contents
Advertisement
Quick Links
INSTALLATION and OPERATION MANUAL
Self-Priming Centrifugal Pumps
IMPORTANT: Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program, product
changes may occur. As such Crane Pumps & Systems, Inc., reserves the right to change product
without prior written notification.
PUMPS & SYSTEMS
A Crane Co. Company
420 Third Street/P.O. Box 603
Piqua, Ohio 45356-0603
Phone: (937) 778-8947
Fax: (937) 773-7157
www.cranepumps.com
MENU
HOME
BARNES
83 West Drive, Brampton
Ontario, Canada L6T 2J6
Phone: (905) 457-6223
Fax: (905) 457-2650
Manual Index
®
Universal Drive:
Model:
30MU
DISCONTINUED
Parts may
NOT be available
American Bureau of Shipping
Certificate No. 96-C11691-X
Form No. 029294-Rev. D
Advertisement
Table of Contents
Related Manuals for Barnes 30MU
Summary of Contents for Barnes 30MU
- Page 1 Manual Index ® BARNES INSTALLATION and OPERATION MANUAL Self-Priming Centrifugal Pumps Universal Drive: Model: 30MU DISCONTINUED Parts may NOT be available American Bureau of Shipping Certificate No. 96-C11691-X IMPORTANT: Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur.
-
Page 2: Table Of Contents
START-UP REPORT WARRANTY REGISTRATION Other brand and product names are trademarks or registered trademarks of their respective holders. ® Barnes is a registered trademark of Barnes Pumps, Inc. © Barnes Pumps, Inc. 1984, 2002 Alteration Rights Reserved. Printed in U.S.A. -
Page 3: Safety First
WARNING ! Operation against a closed discharge valve will cause premature bearing Barnes® Pumps, Inc. is not responsible for losses, injury, and seal failure on any pump, and on end suction or death resulting from a failure to observe these safety and self priming pump the heat build may cause the generation of precautions, misuse or abuse of pumps or equipment. -
Page 4: Pump Specifications
MENU HOME Manual Index SECTION A - PUMP SPECIFICATIONS SUCTION/DISCHARGE: 4" (102mm) x 4" (102mm) FNPT. BEARING-PUMP END: LIQUID TEMPERATURE: 160°F (71°C) Continuous. Design: Tapered Roller VOLUTE/WEARPLATE: Cast Iron ASTM A-48, Class 30. Lubrication: SEAL PLATE: Cast Iron ASTM A-48, Class 30. Load: Radial PEDESTAL:... -
Page 5: General Information
For the location of the nearest Barnes Pumps Service from being drawn into the impeller. The strainer should Center, check your catalog, your Barnes Pumps, Inc. -
Page 6: Operation
MENU HOME Manual Index C-4) Driver: Examine and replace any parts showing wear or damage. Read Engine Or Motor Manufacturer’s Instruction Book. When replacing gasket and weight assembly onto pump body make sure that HINGE section of gasket (3) is at TOP and that LARGE weight is on PUMP SIDE of gasket. -
Page 7: Replacement Parts
MENU HOME Manual Index SECTION: F REPLACEMENT PARTS E-4) Impeller Shaft and Bearing Service: Remove pump body, impeller, shaft seal and seal plate as F-1 ORDERING REPLACEMENT PARTS: outlined in Section E-2 and E-3. When ordering replacement parts, ALWAYS furnish the following information: Pull slinger (24) from shaft (32). -
Page 8: Trouble Shooting
MENU HOME Manual Index TROUBLE SHOOTING CHART SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Little or no discharge 1. Casing not filled with water 1.Fill pump casing. Using a foot-valve will extend and unit will not prime pump life and facilitate immediate priming. 2. -
Page 9: Cross-Section
MENU HOME Manual Index... -
Page 10: Exploded View
MENU HOME Manual Index... -
Page 11: Parts List
MENU HOME Manual Index PARTS LIST ITEM QTY. DESCRIPTION PART No. Suction Flange 001485 Hex Nut 5/8-11, Steel 002505 Gasket 001486 Weight, Large 5.00" O.D. 067501 Weight, Small 3.75" O.D. 033862 Hex Hd Screw 1/4-20 x 1.00" Lg, Stainless 1-7-1 Lockwasher 1/4"... - Page 12 MENU HOME Manual Index NOTES:...
-
Page 13: Returned Goods Policy
MENU HOME Manual Index IMPORTANT ! WARRANTY REGISTRATION Your product is covered by the enclosed Warranty. Complete the Warranty Registration Form and returned to Crane Pumps & Systems, Inc. Warranty Service Group IMPORTANT! If you have a claim under the provision of the warranty, contact your local Crane Pumps &... - Page 14 HOME Manual Index ® BARNES Limited Warranty We warrant to our immediate customer and to the ultimate consumer that products of our manufacture will be free of defects in material and workmanship under normal use and service for the following time periods, when installed and maintained in accordance with our instructions.
- Page 15 Pump Owner’s Name Address Location of Installation Person in Charge Phone Purchased From (Barnes Pumps’ Representative/Distributor) Pump Model Serial No. Part Number Rotation: Direction of Impeller Rotation (Use C/W for clockwise, CC/W for counter-clockwise) Do Shafts Turn Freely By Hand: Electric Motor Manufacture: Serial No.
- Page 16 MENU HOME Manual Index Barnes Pumps Control Panel Part No. Number of pumps operated by control panel. NOTE: At no time should holes be made in top of control panel, unless proper sealing devices are utilized. Control panel manufactured by others.
-
Page 17: Start-Up Report
MENU HOME Manual Index START-UP REPORT ENGINE DRIVEN This report is designed to insure the customer that customer service and a quality product are the number one priority with Crane Pumps & Systems, Inc. Please answer the following questions completely and as accurately as possible. Mail this form to: In U.S.A. - Page 18 MENU HOME Manual Index I have received the previous information (Name of Operator) Name of Company Date: I Certify this report to be accurate (Name of Start-Up person) Employed by Date: Date and Time of Start-Up Present at Start-Up: ( ) Engineer ( ) Operator ( ) Contractor ( ) Other...
-
Page 19: Warranty Registration
MENU HOME Manual Index IMPORTANT ! WARRANTY REGISTRATION Your product is covered by the enclosed Warranty. Complete the Warranty Registration Form and returned to Crane Pumps & Systems, Inc. Warranty Service Group IMPORTANT! If you have a claim under the provision of the warranty, contact your local Crane Pumps &... - Page 20 MENU HOME Manual Index FOLD HERE AND TAPE, DO NOT STAPLE PLACE STAMP HERE CRANE PUMPS & SYSTEMS, INC. WARRANTY SERVICE GROUP 420 THIRD STREET P.O. BOX 603 PIQUA, OHIO 45356-0603 - U.S.A.
Need help?
Do you have a question about the 30MU and is the answer not in the manual?
Questions and answers