Page 1
Page 1 of 4 FELIX 3.0 - Quick start guide Remove miscellaneous bag and Remove tie-wrap on optional filament and or other parts belt and on guide rail Place filament roll(s) and guide the Snap filament holder into frame Mount handle filament to the extruder entry Insert dust cleaner disc(s) Insert Teflon tubes...
Page 2
Page 2 of 4 FELIX 3.0 - Quick start guide Three adjustment points, calibrate distance between nozzle and table along displayed ≈5cm lines. ≈1 mm Move table up, Turn Nut to adjust height. by turning the Slowly move extruder spindle by hand along x-axis to verify that Turn nut to table is level...
Page 3
Page 3 of 4 FELIX 3.0 - Quick start guide Calibration No air gap Successful No contact between nozzle and table Turn spindle by hand to obtain a minimum distance of 10mm Too far: Big gap Home Z Press Too close: Nozzle hits table...
Page 4
Page 4 of 4 FELIX 3.0 - Quick start guide Check if settings match Wait until temperature set points are reached. Make sure nothing is blocking any axes Insert Filament Extrude until filament comes out of nozzle Note: Only works when ...