Bosch Solution 6+6 Wireless On/Off Quick Reference Manual page 5

Solution 6+6 Wireless On/Off
Qui c k St ar t
The following steps will enable you to use the
default values as set in the factory. The default settings allow the panel to communicate in Contact ID format.
1. Connect AC power to the unit.
The MAINS indicator will remain on as will the AWAY indicator. The unit is now in the armed state.
2. The back-up battery should now be connected.
3. Enter the default Master Code
extinguish. The panel is now in the disarmed state. Installer's Programming Mode can now be accessed.
4. Enter the factory default Installer Code
LED's will now flash simultaneously.
5. Enter the primary and secondary telephone numbers and the Subscriber ID Number.
6. Set the time for the test reports if this option is required. Any other programming changes required can also be
made, otherwise the factory programming default settings will be used.
960
7. Enter command
return to the unarmed state and is now ready for use.
8. Using a Master Code set the date and time.
•
Enter
•
Enter the day of the month, then the month, then the year, then the hour, then the minute using the format
(DD, MM, YY, HH, MM).
•
Press the
Zone Def aul t Set t i ngs
The default zone settings are as listed in the table below.
Note: The example given in this Quick Reference Guide is a simplified description of how to configure the
panel. The system offers many other programmable features which are described in detail in the
Solution 6+6 Wireless On/Off Installation Manual (MA670I).
Quick Reference Guide
Solution 6+6 Wireless On/Off
2580
followed by the
1234
followed by the button to exit Installer's Programming Mode. The panel will
6
+ + .
button when finished.
Zone No.
Delay
1
2 & 3 Handover
4 & 5 Instant
24 Hour
6
Electronics Design & Manufacturing Pty Limited
button.
button. The STAY and AWAY
followed by the
Zone T y pe
ISSUE 1.20
control panel with the
The AWAY indicator will
Page 5