Advertisement
Solution 6+6 Wireless On/Off
Hol d Down F unc t i ons
Hold Down Functions have been incorporated to allow easy activation of specific operations. When a button is held
down for two seconds, two beeps will be heard and a particular function will operate. These functions are listed below.
F unc t i on
AWAY
STAY
0
1
2
3
4
5
6
7
8
9
T es t i ng T he Di al l er
Telephone monitor mode allows the remote codepad to be used for a visual representation of data transmissions
between the control panel and the base station receiver. The dialling sequence is also shown in this mode.
The codepad will beep once every two seconds while telephone monitor mode is turned on regardless of whether the
system is in Installer's Programming Mode or normal operating mode. The first five indicators are used to display the
progressive steps for a transmission to the base station receiver.
How T o T ur n T el ephone Moni t or Mode On and T es t T he Di al l er
1.
Enter your
Three beeps will be heard.
9
2.
Hold Down button
How T o T ur n T el ephone Moni t or Mode Of f
1.
Enter your
Two beeps will be heard.
Each zone contains five locations. The first four locations determine how the zone operates, while the last location
contains the dialler reporting information.
Page 8
Quick Reference Guide
Arm The System in AWAY Mode
Arm The System in STAY Mode
Reserved
Horn Speaker Test
Bell Test
Strobe Test
Toggle Day Alarm On and Off
Fault Analysis
Initiate a Modem Call
Reset Latching Outputs
Codepad ID Beeper Tone Change
Initiate a Test Report
Hold Down Functions
Zone I ndi c at or
Telephone Line Seized
1
2
Dialling Phone Number
3
Handshake Received
4
Data Is Being Transmitted
Kiss-Off Received
5
None
Telephone Line Released
Telephone Monitor Mode Indications
7
followed by
and the
for two seconds until two beeps are heard to initiate a test report.
7
followed by
and the
Bosch Security Systems Pty Limited
Des c r i pt i on
Di al l i ng Ev ent
button.
button.
ISSUE 1.20
Advertisement
