Pr Ogr Ammi Ng Us I Ng A Codepad - Bosch Solution 6+6 Wireless On/Off Quick Reference Manual

Solution 6+6 Wireless On/Off

Pr ogr ammi ng Us i ng a Codepad

The system must be in a disarmed state with no flashing zone alarm memories, this can be achieved by entering the
followed by the
To access the Installer's Programming Mode, enter the four digit
factory default Installer Code is
will flash simultaneously. If a long beep is heard, check the system for alarm memory. The combination of the MAINS
and ZONE indicators will indicate the data stored in the first location (LOCATION 000).
Dat a Zone 1
Val ue L ED
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
E x ampl e
To move to a particular programming location, enter the location number required followed by the
The data of the new location will now be displayed.
To move to the next location, press the
location will be displayed via the zone LED indicators.
If you press the button without previously entering a location number, the system will step back one location.
To change data in the current location, enter the new value followed by the
data into the location and still leave you still positioned at the same location.
To proceed to the next location, press the
To exit the Installer's Programming Mode, enter the command
will be heard and the system will return to normal.
For a more detailed explanation, refer to the
Note: The valid address range for a
Page 4
Quick Reference Guide
button. The factory default Master Code is
1234
. Three beeps will be heard and both the AWAY and the STAY indicators
Zone 2 Zone 3 Zone 4
L E D L E D L E D
Zone Indicators When Programming
button. This will step you to the next location and the data in that
button. The next locations data will now be displayed.
Installation Manual (MA670I)
Solution 6+6 Wireless On/Off
Bosch Security Systems Pty Limited
2580
followed by the
Zone 5 Zone 6 Zone 7
L E D L E D L E D
button. This will store the new
960
followed by the
Solution 6+6 Wireless On/Off
control panel is 000 to 213.
ISSUE 1.20
.
button. The
Zone 8 Mai ns
L E D L ED
button.
button. Two beeps