Download Print this page

Bosch Solution 6+6 Wireless On/Off Quick Reference Manual page 6

Hide thumbs Also See for Solution 6+6 Wireless On/Off:

Advertisement

Solution 6+6 Wireless On/Off
I ns t al l er ' s Pr ogr ammi ng Commands
There are several commands that can be invoked to perform the functions as listed below. These commands only
operate while you are in the Installers Programming Mode. To invoke the command, press in the corresponding
numerical code then press the
Command
958
959
960
961
962
963
964
965
966
999
I ns t al l er Code F unc t i ons
Installer Code Functions are designed to allow the installer to perform various system tests without the need to know a
Master Code.
The
is entered followed by a
mode. If a button is not pressed within any sixty second period, the mode will automatically terminate.
These functions can only be carried out while the system is in a disarmed state.
F unc t i on
0
1
2
3
4
5
6
7
8
9
Mas t er Code F unc t i ons
Page 6
Quick Reference Guide
button.
Enable and Disable Zone Status Mode
Test Programming Key
Exit Installer's Programming Mode
Set Defaults For Contact ID Format (Factory Default Settings)
Copy The Panel Memory To The Programming Key
Copy The Programming Key Data To The Panel Memory
Wipe Programming Key
Set Defaults For Domestic Reporting
Enable and Disable Automatic Stepping of Locations During Programming
This Command Displays The
Using An BOSCH Hand Held Programmer
Installers Programming Commands
+
Fault Analysis Mode
Reserved
Set Number Of Days Until The First Test Report
Event Memory Recall
Walk Test Mode
Satellite Siren (BOSCHSAT) Service Mode
Initiate Modem Call
Turning Telephone Monitor Mode On and Off
Reserved
Send A Test Report
Installer Code Functions
Bosch Security Systems Pty Limited
F unc t i on
Panel's "Software Version" Number When
Solution
digit then the
button to enter you into a particular
+
Des c r i pt i on
ISSUE 1.20

Advertisement

loading
Need help?

Need help?

Do you have a question about the Solution 6+6 Wireless On/Off and is the answer not in the manual?