Table of Contents
Advertisement
Direct Drive tapping unit with touch screen multiple control panel
SERVICE
M8X10
PROGRAM
(page 5)
Loading a program:
1
2
1.
From main screen, select SERVICE and then PROGRAM
2.
Tap "Program Select"
Loading a program:
3.
Scroll and select the program from the menu
1- from main screen, select SERVICE and then PROGRAM.
4.
Press LOAD
2- tap "Program Select"
5.
Make sure that the program has been loaded: the name should appear in green characters on top. Press EXIT.
3- scroll and select the program from the menu
4- press LOAD.
5- make sure that the program has been loaded: the name should appear in green characters on top. Press EXIT.
ATTENTION! In case the loaded program has a different rotation (left/right threading) than the previous one, the
ATTENTION:
panel must be turned off and on before starting the threading process otherwise it won't change the direction.
In case the loaded program has a different rotation (left/right threading) than the previous one, the panel must
be turned off and on before starting the threading process otherwise it won't change the direction
.
SERVICE
PROGRAM5
PROGRAM
PROGRAM5
1
g ) DIAgNOsTIC
This function allows to perform an engine check-up by pressing DIAGNOSTIC START CYCLE ( the button will show a
flashing red light). Once the check-up is complete, the screen will display the following data: value regarding motor
performance, temperature, power consumption during clockwise and counterclockwise rotation, engine timing
degrees. The E.v. oil e Test E.v. Tap keys allow the operator to check the functioning of the electrovalves which control
the lubrication and the tapping unit. By pressing E.v. oil the operator should see an oil stream coming out from the
lubrication outlet and by pressing Test E.v. Tap, the tap holder of the tapping unit should descend.
H) ALArm HIsTOrY
It displays the alarm history and the total amount of threads made by the machine. This information may be very
helpful to identify anomalies during the threading process.
The BRUSH icon allows to clear the alarm history and the RESET button allows to clear the number of cycles.
I) LANgUAgE sELECTION
This function allows to select the language in which alarm list is displayed: italian, english and german.
BrIgHTNEss
Brightness of the screen can be adjusted using the BrIgHTNEss slider in the SERVICE menu.
CHANgE OF sUPEr UsEr PAsswOrD
Super User password that enable SET UP and SERVICE functions can be changed following
these steps:
•
If the padlock icon in the display is closed (fig. a), press the icon
current password to enter into SUPER USE mode. The box SUPER USE will turn green
(Fig. b)
•
Press Bordignon logo on the display. A page for setting a password will appear (Fig. b)
•
Press box "new password" (Fig. c). A keyboard will appear. Type the new password
and then press ENTER.
•
Once the password has been entered, press SET (Fig. c) until it turns green. The box
on top will now show the new password. Press EXIT
•
Close the padlock typing 1111. Press EXIT
In case of lost password, contact the reseller
M5x8
PROGRAM9
PROGRAM0
PROGRAM1
PROGRAM1
3
PROGRAM5
PROGRAM5
program1
M3X6
program3
2
view of the last loaded program
M5x8
PROGRAM0
M8x...
4
PROGRAM5
M3x6
PROGRAM5
3
10
M5x8
PROGRAM0
M8x10
5
PROGRAM5
M3x6
4
and type the
M8x10
M8x10
M8x10
6
M3x6
M3x6
5
a
b
c
12
Advertisement
Table of Contents
