Brother MFC MFC-5840CN Manual page 141

DIFFICULTY
™
PhotoCapture Center
Removable Disk does not
work properly.
Cannot access Removable
Disk from Desktop icon.
Network Difficulties
I cannot print over the Network
11 - 13 TROUBLESHOOTING AND ROUTINE MAINTENANCE
SUGGESTIONS
Difficulties (MFC-5840CN only)
a)Have you installed the Windows
If not, do the following:
1. Disconnect the USB cable.
2. Install the Windows
Guide. After the installation the PC will be automatically restarted.
3. Wait about 1 minute after you reboot the PC, and then connect the
USB cable.
b)Take out the media card and put it back in again.
c) If you have tried "Eject" from within Windows
media card before you continue.
d)If an error message appears when you try to eject the media card, it
means the card is being accessed.
Wait a while and then try again.
e)If all of the above do not work, please turn off your PC and MFC, and
then turn them on again.
(You will have to unplug the power cord of the MFC to turn it off.)
Make sure you have inserted the media card into the media slot.
Make sure that your MFC is powered on and is On Line and in Ready
mode. Print Network Configuration list. (See Printing reports on page
7-1.) Then the current settings of the network are printed. Reconnect the
LAN cable to the hub to verify that the cabling and network connections
are good. If possible, try connecting the MFC to a different port on your
hub using a different cable. If the connections are good, the machine
shows LAN Active for 2 seconds.
®
2000 update?
®
2000 update. Please see the Quick Setup
®
, you must take out the