Advertisement
Command
code
"00": Cancel CH1 AT
"01": Execute CH1 AT
"10": Cancel CH2 AT
03
"11": Execute CH2 AT
"F0": Cancel CH1, CH2 AT
"F1": ExeculteCH1, CH2 AT
"00" or "10": Backup
04
"01" or "11": RAM
05
"00" or "10"
06
"00" or "10"
07
"00" or "10"
08
"00" or "10"
"00": Auto for CH1
"01": Manual for CH1
"10": Auto for CH2
09
"11": Manual for CH2
"F0": Auto for CH1, CH2
"F1": Manual for CH1, CH2
0A
"00" or "10"
0B
"00" or "10"
"00": Cancel alarm latch for CH1
"01": Cancel alarm latch 2 for CH1
"02": Cancel alarm latch 3 for CH1
"0F": Cancel all alarm latches for CH1
"10": Cancel alarm latch for CH2
"11": Cancel alarm latch 2 for CH2
0C
"12": Cancel alarm latch 3 for CH2
"1F": Cancel all alarm latches for CH2
"F0": Cancel alarm latch for CH1, CH2
"F1": Cancel alarm latch 2 for CH1, CH2
"F2": Cancel alarm latch 3 for CH1, CH2
"FF": Cancel all alarm latches for CH2
*1
Upgraded pulse output models and analog output models can support these commands.
*2
Command codes for which the related information is indicated as "
same command for both CH1 and CH2. You can use either value in the related information. (The result will be the
same.)
• To enable "Use System Area" in the system area setting of GP-Pro EX may cause a
• You can set only Read Area Size for the system area available to use in the Temperature Controller.
Please refer to the GP-Pro EX Reference Manual for Read Area Size.
Cf. GP-Pro EX Reference Manual "LS Area (Direct Access Method Area)"
• Please refer to the precautions on manual notation for icons in the table.
• Even if you use the nonexistent address, read error may not be displayed. In this case, "0" is
retained for the read data. Note that the writing error is displayed.
GP-Pro EX Device/PLC Connection Manual
Related information
*1
*1
*1
*1
malfunction. Do not set "Use System Area".
"Manual Symbols and Terminology"
Temperature Controller CompoWay/F Driver
* 2
Command comment
ATexecute/cancel
Write mode
Save RAM data
Soft reset
Setting area 1 transfer
Protect level transfer
Auto/Manual
PV hold
Initialize settings
*1
*1
*1
*1
*1
*1
Cancel alarm latch
*1
*1
*1
*1
*1
*1
44
Device address
A0003
A0004
A0005
A0006
A0007
A0008
A0009
A000A
A000B
A000C
"00" or "10"" or ""01" or "11"" use the
Advertisement
