Advertisement
Command
code
06
00
07
00
08
00
00: Auto mode
09
01: Manual mode
00: Default value
0B
01: Value for default value setting service
00: Reset
11
01: Start
*1
A soft reset will not respond.
• To enable "Use System Area" in the system area setting of GP-Pro EX may cause a
• You can set only Read Area Size for the system area available to use in the Temperature Controller.
Please refer to the GP-Pro EX Reference Manual for Read Area Size.
Cf. GP-Pro EX Reference Manual "LS Area (Direct Access Method Area)"
• Please refer to the precautions on manual notation for icons in the table.
• Even if you use the nonexistent address, read error may not be displayed. In this case, "0" is
retained for the read data. Note that the writing error is displayed.
GP-Pro EX Device/PLC Connection Manual
Related information
malfunction. Do not set "Use System Area".
"Manual Symbols and Terminology"
Temperature Controller CompoWay/F Driver
Command comment
*1
Soft reset
Setting area 1 transfer
Protect level transfer
Auto/Manual
Initialize settings
Program start
39
Device address
A0006
A0007
A0008
A0009
A000B
A0011
Advertisement
