Figure 9. Bottom Support Bracket Assembly; Figure 10. Guide For Pole Mounting - ADTRAN T200 H2TU-R Installation And Maintenance Manual

sealing washer
flat washer
split washer
Bolt torque: 100-110 in-lbs
Insert all unused fasteners

Figure 9. Bottom Support Bracket Assembly

on the through bolt, the nut on the other end can
be tightened to snug the bolt head to the
mounting bracket. Do not torque at this time.
11. Ensuring the cabinet is secure to the pole, relieve
tension on the hoist device but do not remove.
This allows positioning of the cabinet.
12. At the bottom of the cabinet insert a temporary
spacer between the cabinet and the pole so the
cabinet hangs plumb. The space between the
pole and the cabinet should be the same from top
to bottom.
13. At the bottom of the cabinet, position and angle
the support brackets so the short ends are flush
against the pole. Using a level, ensure the
cabinet is plumb then tighten the bolts (100-110
in-lbs) securing the brackets to the cabinet.
14. Using two 3/8 inch x 2 1/2 inch lag screws
attach the bottom support brackets to the pole.
CAUTION
If bottom bracket adjustment is required,
loosen the bottom support bracket bolts before
adjusting cabinet. Failure to loosen bolts will
cause damage to the sealing washers.
15 Tighten all fasteners to the proper torque.
Remove the lifting gear from the cabinet.
8
bolt
*3/8" x 2-1/2" Lag Screws (2)
*Customer furnished hardware

Figure 10. Guide for Pole Mounting

16. If the unused lifting detail is to be removed,
replace the fasteners removed in step 4 ensuring
the sealing washer is installed next to the
cabinet.
All unused threaded openings in the cabinet
must have their designated fasteners inserted
and tightened to ensure a proper seal.
H-Frame Mount
For mounting the cabinet to an H-Frame, follow the
same procedure as for Pole Mounting except
substitute acceptable 3/8 inch bolts, nuts, and washers
(customer supplied) instead of lag screws for attaching
the bottom pole mount support brackets to the
H-frame. ADTRAN recommends the use of steel cross
bars between the two poles to ensure adequate
strength. The H-frame facility must be able to bear the
weight of a fully-equipped cabinet (200 Lbs).
Splice Wires (Pre-Stubbed Version or Internal
Splice Module Version)
A T200/T400 Test Access Card (part number
1244065L1, purchased separately) can be inserted into
a slot to assist in circuit or continuity tests. Refer to
ADTRAN Test Access Card Practice, Section
61244065L1-5, for more information.
Section 61150090L1-5A, Issue 1
*1/2" Thru-bolt
NOTE
*1/2" Nut
*1/2" Washer
Pole Mount
Bracket
Pole Support
Brackets (2)
61150090L1-5A