Assembling And Installing; Installation; Opening The Housing; Installing The Camera - Videotec NTW Instruction Manual

6 Assembling and
installing
Only specialised personnel should be
h g
allowed to assemble and install the device.
h g In the 230Vac powered configuration
it is necessary to insert a 1 0 unipolar
main switch (open contact distance d>3
mm) upstream on the power line. This
switch should be used to disconnect the
power supply before carrying out any
maintenance operation or before opening
the housing.

6.1 Installation

6.1.1 Opening the housing

To open the housing, unscrew the 4 screws on the
back flange using the allen wrench supplied.
Slide out the rear cover plate of the housing, taking
care to leave the sealing washer in its seating.
Fig. 01
It will then be easy to gain access to the inside of
the housing without having to dismantle it from the
support bracket if already assembled.

6.1.2 Installing the camera

This section describes how to install the camera
inside the housing.
Open the housing following the instructions given
above (Fig. 01, page 5).
Attach the camera to the internal slide with the 1/4"W
screw using the insulating bush. If necessary use the
spacers supplied and the appropriate 1/4"W screws
so as to position the camera and lens correctly.
Fig. 02
Make the correct electrical connections for the
camera and lens, passing the cables through the
cable glands. Make sure the latter are firmly locked
in place.
Close the housing by proceeding in the reverse order
to that described above (Fig. 01, page 5). Make sure the
sealing ring on the rear flange is correctly inserted in
its seating so as not to damage it.
Attach the housing to the bracket if this has not been
assembled already.
Fig. 03
5