Product Description And Type Designation; Preparing The Product For Use; Assembling And Installing - Videotec OUPT5CPU Instruction Manual

4 Identification
4.1 Product description and type
designation
Spare part CPU board for ULISSE NETCAM series.
4.2 Product markings
See the label attached to the product.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Unpacking and contents
5.1.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
5.1.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• CPU board
• Bolts and screws
• Instructions manual
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
When returning a faulty product we recommend
using the original packaging for shipping.
2

6 Assembling and installing

The assembly and installation must be
performed only by skilled personnel.
To avoid compatibility problems, the Pan &
Tilt firmware must be upgraded.
6.1 Installation
6.1.1 CPU board installation
Remove the upper unit (01) from the base (02) by
unscrewing the fixing screws (03).
Fig. 1
Unscrew the screws (01) and detach the connectors
(02).
02
Fig. 2
01
02
01
01
02
03
02