Installing The Camera Power Supply Kit; Limits To Use; Maintaining And Cleaning; Window Cleaning - Videotec NTW Instruction Manual

6.1.5 Installing the camera power
supply kit
This section describes how to install the camera
power supply kit inside the housing. It is possible to
install a number of different types of power supply.
The input voltage may be 230Vac or 115Vac while the
output voltage may be 12Vdc or 24Vac, 400mA.
Open the housing following the instructions given
previously (Fig. 01, page 5).
Position the power supply to match the attachment
holes provided on the inner side of the rear flange of
the housing.
Attach the power supply to the rear plate of the
housing using the screws supplied with the power
supply kit.
Fig. 06
Make the power supply-camera electrical
connections.
Close the housing, proceeding in the reverse order to
that described above, making sure the sealing ring on
the rear flange is correctly inserted in its seating so as
not to damage it (Fig. 01, page 5).

6.1.6 Limits to use

The housing has a front flange with an Ø80mm, Zinc-
Selenium (4mm thick)or Sapphire glass (1mm thick).
Wavelength (µm)
Fig. 07 Zinc-Selenium transmission curve. Field
of application: from 7.5 to 14¬μm.
Wavelength (µm)
Fig. 08 Sapphire transmission curve. Field of
application from 0.75 tp 14¬μm.
7 Maintaining and cleaning

7.1 Window cleaning

Surface dirt should be rinsed away with water and
then the window cleaned with a neutral soap diluted
with water, or specific products for spectacle lens
cleaning. These should be applied with a soft cloth.
Avoid ethyl alcohol, solvents,hydrogenated
h g
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
8 Disposal of waste
materials
This symbol mark and recycle system
n g
are applied only to Eu countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
sp 1mm
sp 2mm
7