VTech CTM-S2116 User Manual page 3

Sip 1-line hidden base with cordless color handset and charger, sip 1-line hidden base, sip 1-line cordless color handset and charger
Hide thumbs Also See for CTM-S2116:
Table of Contents

Advertisement

Improper adjustment of other controls
may result in damage and often
requires extensive work by an authorized
technician to restore the product to
normal operation.
• If the product has been dropped and
the telephone base and/or handset has
been damaged.
• If the product exhibits a distinct change in
performance.
15. Avoid using a telephone (other than
cordless) during an electrical storm.
There is a remote risk of electric shock
from lightning.
16. Do not use the telephone to report a
gas leak in the vicinity of the leak. Under
certain circumstances, a spark may be
created when the adapter is plugged into
the power outlet, or when the handset is
replaced in its cradle. This is a common
event associated with the closing of any
electrical circuit. The user should not plug
the phone into a power outlet, and should
not put a charged handset into the cradle,
if the phone is located in an environment
containing concentrations of flammable
or flame-supporting gases, unless there
is adequate ventilation. A spark in such
an environment could create a fire or
explosion.
Such
include: medical use of oxygen without
adequate ventilation; industrial gases
(cleaning solvents; gasoline vapors; etc.);
a leak of natural gas; etc.
17. Only put the handset of your telephone
next to your ear when it is in normal talk
mode.
18. The power adapters are intended to
be correctly oriented in a vertical or
floor mount position. The prongs are not
designed to hold the plug in place if it is
environments
might
plugged into a ceiling, under-the-table or
cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose
of batteries in a fire. They may explode.
Check with local codes for possible
special disposal instructions.
20. In wall mounting position, make sure to
mount the telephone base on the wall
by aligning the eyelets with the mounting
studs of the wall plate. Then slide the
telephone base down on both mounting
studs until it locks into place. Refer to the
full instructions in Installation in the user's
manual.
21. Listed PoE (The product is considered not
likely to require connection to an Ethernet
network with outside plant routing).
CAUTIONS
CAUTIONS
• Keep small metallic objects such as
pins and staples away from the handset
receiver.
• There may be a risk of explosion if a wrong
type of handset battery is used. Use only
the supplied rechargeable battery or
replacement battery. Dispose of used
batteries according to the information in
The RBRC® seal in this user guide.
SAVE THESE INSTRUCTIONS
EN - 3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ctm-s2110Ngc-s3410hcSip contemporary seriesCtm-s2115

Table of Contents