Remote Control Commands - Brother FAX FAX-1030E User Manual

Remote Control Commands

Follow the commands below to access features remotely. When you call the fax machine and enter
your Remote Access Code (1 5 9
remote control command.
Remote control commands
91 Playing voice messages
1 Skip back
2 Skip next
9 STOP Playing
93 Erase all ICM
94 Play and Record OGM in
memory
1 Play 1 MSG CTR OGM
2 FAX/TEL OGM
3 PAGING OGM
2 Record 1 MSG CTR OGM
2 FAX/TEL OGM
3 PAGING OGM
95 Changing Fax
Forwarding/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
71
Chapter 12
), the system will signal you with two short beeps to enter a
After one long beep, the machine plays In-Coming Message
(ICM).
Press 1 while listening to an ICM to play it again. If you press
1 before a message, you will hear the previous message.
While playing ICM, you can skip to next message.
Stop playing the ICM.
If you hear one long beep, the erase is accepted. If you hear
three short beeps, you cannot erase because all voice
messages have not been played, or there is no voice message
to erase.
*This code erases all recorded messages, not one at a time.
The machine plays the selected OGM. You can stop playing
OGMs by pressing 9.
After one long beep, you can record the selected OGM. You
will hear the message played once. You can stop recording
the message by pressing 9.
If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the
conditions have not been met (Example: registering paging
number).
You can register your fax forwarding number by using
4.FAX FWD NO. (See Changing the Fax Forwarding
Number, page 74.) Once you have registered the number, the
machine will automatically turn to "FAX FWD:ON" mode.
Then retrieve a Memory Status List by entering 9 6 1 to make
sure that the Fax Forwarding number you registered is correct
in the List.
Detail Operation