Table of Contents
Advertisement
Remote Control Commands
Follow the commands below to access features remotely. When you
call the fax machine and enter your Remote Access Code (3 digits
followed by
), the system will signal you with two short beeps to
enter a remote control command.
Remote control commands
91 Playing voice messages After one long beep, the machine plays ICM.
1 Skip back
2 Skip next
9 STOP Playing
93 Erase all ICM
94 Play and Record OGM in
memory
1 Play 1 TAD MSG
2 F/T MSG
3 PAGING MSG
2
1 TAD MSG
Record
2 F/T MSG
3 PAGING MSG
Detail Operation
Press 1 while listening to an ICM to play it again. If
you press 1 before a message, you will hear the
previous message.
While playing ICM, you can skip to next message.
Stop playing the ICM.
If you hear one long beep, the erase is accepted. If
you hear three short beeps, you cannot erase
because all voice messages have not been played,
or there is no voice message to erase.
*This code erases all recorded messages, not one
at a time.
The machine plays the selected OGM. You can
stop playing OGMs by pressing 9.
After one long beep, you can record the selected
OGM. You will hear the message played once. You
can stop recording the message by pressing 9.
MESSAGE MANAGER 8 - 16
Advertisement
Table of Contents
