Remote Commands - Brother FAX FAX-1030E User Manual

Remote Commands

Follow the commands below to access features remotely. When you call the fax machine and enter
your Remote Access Code (1 5 9
remote control command.
Remote control commands
95 Change Fax Forwarding
Setting
1 OFF
2 Fax forwarding
4 FAX FWD No.
6 FAX STORAGE ON
7 FAX STORAGE OFF
96 Retrieve FAX
1 Memory Status List
2 Retrieve all FAX
3 Erase FAX in the
memory
97 Check the receiving status
1 DOC
98 Change Answer Mode
1 TAD
2 F/T
3 FAX
90 Exit
), the system will signal you with two short beeps to enter a
Detail Operation
If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the
conditions (ex. registering fax forwarding) have not been
completed. You can register your fax forwarding number by
using 4.FAX FWD NO. Once you have registered the
number, the machine will automatically turn to "FAX
FWD:ON" mode. Then, receive a Memory Status List by
entering 961. Check the List to make sure the Fax
Forwarding number you registered is correct. Now the
machine will start Fax Forwarding.
You can set FAX STORAGE ON or OFF. (Switching Fax
Storage OFF is only possible if there are no faxes stored in
the memory, or if all faxes have been erased using Remote
Control 9 6 3.)
You must use a remote fax machine in order to receive a List
of stored fax message(s).
If you hear one long beep, you can erase fax message(s) from
the memory.
You can check whether your fax machine has received any
fax message(s). If yes, you will hear one long beep. If no, you
will hear three short beeps.
If you hear one long beep, you can change the answer mode.
If you hear three short beeps, you cannot change it.
(Example: There is no TAD MSG when you want to change
to TAD mode.)
After a long beep, you can exit remote control.
Remote Fax Options (Only for FAX-1020e)
60