Remote Control - Palazzetti WT60 3D N16 Installation, Use And Maintenance Manual

10 REMOTE CONTROL

(OPTIONAL)
10.1 Overview
This device allows you to remotely control the
operating parameters of the Ecomonoblocco.
10.2 Pairing at the control panel
Access the screen Info on the control panel dis-
play and navigate on the screen
Remote: scanning ...
Insert the batteries into the remote control (2 x
AAA 1.5 V)
After few seconds the display will change screen,
you will be presented with the following infor-
mation and the remote control will be properly
paired to the control panel:
Remote: connected! Remote paired to the con-
trol panel
Temp [*C]: 26.0 Room temperature detected by
the remote control
Hu [perc]: 34.5 Percentage of humidity detected
by the remote control
Pr [mBar]: 1000 Atmospheric pressure detected
by the remote control
It may be necessary to perform this procedure
again in case the remote control remains outside
of the range of the signal for a long time.
10.3 Keys
1) Switch On / Off (press and hold for about 3
seconds to perform the desired operation)
2) Key momentarily not enabled
3) Power
4) Ventilation
5) Door opening (where provided)
6) Key momentarily not enabled
7) Keys to set the parameters
004778610 - 16/12/2020
ITALIANO ENGLISH
Fig. 40
DEUTSCH
8) Keys to set the parameters
1
3
5
7
10.4 Changing the power
A) Press key 3 which will light up
B) Press one of the buttons 7 to set the desired
value.
10.5 Changing the ventilation
A) Press key 4 which will light up
B) Press one of the buttons 7 to set the desired
value.
10.6 Door opening/closing (where provided)
A) Press key 5 which will light up
B) Press one of the buttons 7 to set the desired
value.
10.7 Reset the remote control
If it is necessary to reset the remote control to
bring it back to the factory configuration, press
buttons 1 and 8 simultaneously for approximately
3 sec.
FRANÇAIS ESPAÑOL
C 2
4
6
8
Fig. 41
85