Palazzetti WT60 3D N16 Installation, Use And Maintenance Manual page 68

5.1 Transportation
Make sure that the lifting carriage has a
payload higher than the weight of the
appliance to be lifted. The full responsi-
bility of the lifting of loads lies with the
person handling the lifting equipment.
Pay particular attention to protecting
wooden flooring or parquet floors in
order to avoid possibly ruining them
due to the weight of the appliance
when moving it.
The product has special connections in the
lower part for mounting of the wheels (Fig. 10).
For wheel mounting see the installation manual
"Wheels kit".
The wheels are not supplied standard
but can be purchased separately.
During lifting, avoid jerking or abrupt movements.
Pay attention to overbalancing.
5.2 Checking the floor where the
appliance will be placed
Check the load capacity of the floor slab.
If a floor is not suitable for supporting the
weight of the appliance, install appropriate
steel plates (A - Fig. 11) or concrete base (A - Fig.
12) equipped with
mesh (B - Fig. 12) to distribute the weight.
For the dimensions of the plates and
of the concrete base, use a qualified
technician.
It is advisable to install the appliance at a height
of approximately 35-40 cm from the floor to the
fire bed to facilitate its use.
68
Fig. 10
10x10x6 electro-welded
To level the appliance, use the dedicated ad-
justment screws located under the feet of the
appliance.
A
A
B
10 mm
Fig. 11
Fig. 12
004778610 - 16/12/2020