Table of Contents
Advertisement
Available languages
Available languages
2610047964.qxp_GTA47W 11/15/19 9:11 AM Page 2
The definitions below describe the level of severity for each signal word. Please read the
!
instructions listed below may result in
serious personal injury.
Fully assemble and tighten all the
fasteners required for this stand.
Periodically check that all fasteners
are attached and adjusted according to
the assembly instructions included in
this manual. A loose stand is unstable
and may shift in use and cause serious
injury.
Turn tool switch off and disconnect
power before mounting to the stand.
Unintended startup during assembly can
cause injury.
Safety Symbols
manual and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
Safety Instructions
Read all instructions.
Failure to follow all
Before operating make sure the entire
unit is placed on a solid, flat, level
surface. Serious injury could occur if
tool is unstable and tips.
Never stand on tool or its stand or use
as ladder or scaffolding. Serious injury
could occur if the tool is tipped or the
cutting tool is accidentally contacted.
Do not store materials on or near the
tool such that it is necessary to stand on
the tool or its stand to reach them.
Use only Bosch replacement parts. Any
others may create a hazard.
-2-
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GTA47W and is the answer not in the manual?
Questions and answers
I’ve had my Bosch GTA47W for a few years. It is great! Recently when trying to lower the blade the wheel turned but the blade did not go up or down. I want to fix it and **** looking for guidance.
The Bosch GTA47W is a support base for table saws, not the saw itself. It does not have blade adjustment features. If you are experiencing a blade adjustment issue, it is likely related to the saw mounted on the base, not the GTA47W. Check the saw's manual for blade adjustment instructions.
This answer is automatically generated
When I fold the table saw up, it is top heavy and tips forward. The stand does not seem to be long enough to balance the saw
To prevent your Bosch GTA47W table saw from tipping forward when folded, ensure that the stand is properly locked in place. When folding or unfolding, keep fingers clear of hinge points and follow these steps:
1. Slightly lift the stand by the handle bar.
2. Rotate the release lever down to clear the locking pins.
3. Pull up and push forward on the stand until it locks in the upright position.
4. When lowering, rotate the release lever and pull back slightly to disengage.
5. Use your foot to pull out the kick bar if needed.
6. Lower the stand carefully until it locks in position.
Always check that the stand is securely locked before moving or storing the table saw.
This answer is automatically generated