Krups BeerTender Manual page 20

1-B90 oneway Amsterdam_UK_1-B90 oneway Amsterdam_UK.qxd 30/05/13 13:57 Page20
The BeerTender
Keg has been
shaken.
The tap handle is
being moved too
slowly.
Beer flows out The tap handle is
too slowly. not open all the way.
The The BeerTender
BeerTender Keg has not been
appliance is chilled for long
dispensing enough in the
warm beer. refrigerator and is
thus not at the right
serving
temperature.
The beer has been
tapped before it
has attained the
right drinking
temperature (see
temperature
indicator).
The The BeerTender
temperature appliance is
indicator on exposed at a too
the control hot temperature or
display never to direct sunlight
reaches a (see also chapter 5
ready-to-drink – "Cooling the keg"
level. and "Installing the
BeerTender").
The control A warm keg was
display shows installed in a cold
an increasing appliance.
temperature.
If you have any problems or queries please contact our
Customer Relations Team first for expert help and advice.
(see details per country at the end of this manual)
20
Wait 4 hours before
dispensing beer.
Firmly and quickly
pull the handle
down and forward
as far as it will go.
Open the tap
completely.
Allow the
BeerTender Keg to
cool in the
refrigerator for
about -12 hours.
Allow the
BeerTender Keg to
cool long enough in
the appliance.
Use the appliance
indoor and move it
in a room where
ambient
temperature does
not exceed 30°C.
Allow the
BeerTender system
to compensate
effect of the
temperature
change. Displayed
temperature should
start decreasing
after 1 hour
maximum.