Connecting To The Power Supply - Krups BeerTender Manual

1-B90 oneway Amsterdam_UK_1-B90 oneway Amsterdam_UK.qxd 30/05/13 13:57 Page11
12°C
30°C
Remove the BeerTender appliance from the packing
container and place it on a dry, clean, level, stable
surface that is sufficiently large to accommodate it.
The temperature of the room must be between 12°C and
30°C. If ambient temperatures is outside these brackets,
your BeerTender will not be able to deliver the set
regulation temperature of 3°C.
Set the drip tray and grate in place at the front of the
appliance. Make sure the drip tray is properly fitted and
positioned.
Do not install the appliance near sources of heat or in
places exposed to direct sunlight.
Note: keep in mind that during use the drip tray will have
to be emptied and rinsed regularly. When the
BeerTender system is not being used, you can remove
the drip tray and place it elsewhere to save space.
Warning! The drip tray must be positioned on a level
surface and must not jut out from the surface it is resting
on.
After installing the BeerTender appliance you must clean
the dispensing spout; this is the only part of the
appliance that will come into contact with the beer.
It is vital that you wash the dispensing spout before
using the appliance for the first time and at least every
time a new keg is connected inside the BeerTender
system. This part can also be washed in a dishwasher.
To clean the spout, remove it from its housing.
After washing the spout, screw it back into place.

Connecting to the power supply

Electricity can be dangerous! Therefore you must always
scrupulously abide by the safety rules.
The appliance must be plugged into a suitable, properly
installed electric socket with an earth connection.
The voltage of the appliance has been set in the factory.
Check that the mains voltage matches the voltage
indicated on the rating plate on the rear of the appliance.
11