Connecting The Scanner; Figure 2-4 Scanner Connections Example - Olympus FlexoFORM User Manual

10-003591-01EN [Q7780031], Rev. 4, January 2020
4. Turn the thumb wheel the opposite way to close the scanner, and tighten it
sufficiently to fasten the wedge in place.
2.4

Connecting the Scanner

The probe and scanner encoder cables are connected to the OmniScan instrument,
and—together with the water supply tube—are held in a cable sleeve attached to the
scanner.
To connect the scanner
1. Connect the LEMO encoder cable to the OmniScan instrument (see Figure 2-4 on
page 28).
2. Connect the probe cable to the OmniScan instrument.
3. Connect the water supply to an Olympus couplant feed unit.
For more details on the recommended CFU03 pump connection, refer to the
CFU03/CFU05/CFU-PWZ Couplant Feed Unit User's Manual.
Encoder and OmniScan
cables, and water supply in
cable sleeve connected to
scanner
LEMO encoder
28 Chapter 2
connector

Figure 2-4 Scanner connections example

Note: Water supply
system may vary.
Water connector
OmniScan probe
connector