Fitting And Removing The Wheels; Folding And Unfolding; Pro-Fix System - JANE RIDER Instructions Manual

1.- FITTING AND REMOVING THE WHEELS

Before using the RIDER pushchair for the first time it is neces-
sary to fit the rear wheels. To fit the wheels press the button
on the middle of the wheel and insert the axle into the rear
wheel bearer and push until it slots firmly into place.
If you need to remove the wheels, press the central button
and take the wheel off.

2.- FOLDING AND UNFOLDING

To unfold your RIDER, lightly press the bar on the back to tilt
the buggy and make it easier to manoeuvre.
handlebar with one hand while you press the locking pedal
at the bottom on the right.
until it clicks and locks into place.
To fold your RIDER place the hammock in the folding position
(P) (see ADJUSTING THE ANGLE OF THE SEAT).
Then pull the two slide catches on the sides and push the
handlebar forwards until the pushchair is completely folded.
7 – 7.a
24
1
2
3 Then hold the
4 Pull the handlebar and unfold
5
6
When folding the pushchair it is useful to place the hammock
facing forwards as this makes it fold up more compactly.
WARNING: You must make sure that the child is kept away from
the pushchair while it is being folded or unfolded. During the-
se operations the appearance of sharp points and compression
areas are inevitable.

3.- PRO-FIX SYSTEM

The chassis of your pushchair includes the PRO-FIX system,
ready to incorporate the following auto safety elements: Mi-
cro, Transporter, Matrix Light and Strata.
system makes it easier to attach and remove these accessories
to and from the chassis, securing them to the chassis in a
quick, simple and safe way. To do this follow the instructions
for these accessories carefully.
WARNING: It is necessary to remove the hammock from the
pushchair to attach any of the auto accessories.
8-8.a The PRO-FIX