Fitting And Removing The Wheels; Folding And Unfolding; Pro-Fix System - JANE RIDER Manual

B. FITTING AND REMOVING THE WHEELS
Before using the RIDER pushchair for the first time it is neces-
sary to fit the rear wheels. To fit the wheels press the button on
the middle of the wheel and insert the axle into the rear wheel
bearer and push until it slots firmly into place.
If you need to remove the wheels, press the central button and
take the wheel off. 2
C. FOLDING AND UNFOLDING
To unfold your RIDER, lightly press the bar on the back to tilt the
buggy and make it easier to manoeuvre.
dlebar with one hand while you press the locking pedal at the bot-
tom on the right. 4 Pull the handlebar and unfold until it clicks
and locks into place. 5
To fold your RIDER place the hammock in the folding position (P1,
P2) (see ADJUSTING THE ANGLE OF THE SEAT).
Next, press the safety button on the left of the handlebar
while pulling both side catches
forwards until it is fully folded.
To fold your RIDER pull the lever on the top part of the seat to set
6
it to the folding position.
1
3 Then hold the han-
7
pushing the handlebar
.b
7
.c
6
- .a
P1: if the hammock is positioned facing forwards.
P2: if the hammock is positioned facing backwards.
! WARNING: You must make sure that the child is kept away
from the pushchair while it is being folded or unfolded. Dur-
ing these operations the appearance of sharp points and
compression areas are inevitable.
D. PRO-FIX SYSTEM
The chassis of your pushchair includes the PRO-FIX system, ready
to incorporate the following auto safety elements: TRANSPORTER,
MICRO, MATRIX, KOOS and NEST.
The PRO-FIX system makes it easier to attach and remove these
accessories to and from the chassis, securing them to the chassis
in a quick, simple and safe way. To do this follow the instructions
7
.a for these accessories carefully.
! WARNING: It is necessary to remove the hammock from the
pushchair to attach any of the auto accessories.
6
.a
6
8 8
- .a
EN
27