Fitting And Removing The Wheels; Unfolding And Folding - JANE KENDO Manual

B. FITTING AND REMOVING THE WHEELS
To fit the rear wheels, keep the central button pressed while inserting
the wheel axle into the axle of the chassis until you feel it slot securely
into place.
1
To remove the rear wheels, keep the central button pressed and take
the wheel off the chassis.
1
To fit the front wheels, keep the front locking button pressed, slot the
front wheel onto the axle and push upwards. Release the front locking
button. You should feel it slot firmly into place.
To remove the front wheels, press the front locking button and take
the front wheel off by pulling it downwards.
WARNING: This action should never be carried out while the
!
baby is in the pushchair.
You should take the wheels off the chassis from time to time and
!
remove any dirt or sand from the wheel axle. Do not immerse
the wheel bearings in water. Use a brush and a damp cloth to
clean the dirt off the wheels.
2
2
C. UNFOLDING AND FOLDING
UNFOLDING
To open your KENDO place it on a flat surface with the handlebar fa-
cing upwards and unfasten the carry strap.
Lift the pushchair by the handlebar until it is fully unfolded and you
hear it lock into place.
4
WARNING: Before using your KENDO pushchair, make sure that
!
all the fastening and locking mechanisms are correctly enga-
ged and secure.
Adjust the handlebar to the required height by releasing the locking
levers and then fastening them again.
FOLDING
Before folding your KENDO pushchair, put the parking brake on
a, take anything out of the basket that could prevent the pushchair
from closing properly, release the steering lock on the front wheels
and remove any of the JANÉ accessories (KOOS, MICRO, MATRIX
8
or NEST seat).
3
12 a-12 b
7
EN
25