Puller So It Pushes Against The Propel; Ler Shaft; Propeller Shaft Housing Puller . 1; Yb-06207 / 90890-06502 Universal Puller - Yamaha Z150P Supplementary Service Manual

LOWR
BACKLASH (COUNTER ROTATION MODELS)
6660
6670
BACKLASH
(COUNTER ROTATION MODELS)
NOTE:
• Do not install the water pump compo-
nents when measuring the backlash.
• Measure both the forward and reverse
gear backlashes.
• If both the forward and reverse gear back-
lashes are larger than specification, the
pinion may be too high.
• If both the forward and reverse gear back-
lashes are smaller than specification, the
pinion may be too low.
MEASURING THE FORWARD GEAR
BACKLASH
1. Measure:
• Forward gear backlash
Out of specification → Adjust.
Forward gear backlash
0.21 - 0.43 mm (0.008 - 0.017 in)
Measuring steps
(1) Set the shift rod into the neutral posi-
tion.
Shift rod wrench
YB-06052 / 90890-06052
(2) Install the propeller shaft housing

puller so it pushes against the propel-

ler shaft.

Propeller shaft housing puller . 1

YB-06207 / 90890-06502
Universal puller......................... 2
YB-06117
Guide plate................................ 3
90890-06501
Center bolt ................................ 4
90890-06504
Center bolt
10 N • m (1.0 kgf • m, 7.2 ft • lb)
– 109 –
E