Connecting Sintesoview - Siemens Connect X300 Commissioning

7.10 Connecting SintesoView

A6V12153163_en--_e
1. Connect to the Sinteso Portal using a tunnel connection [➙ 43].
2. In the status bar, double-click the 'Cloud devices'
3. Only analyze the connection entries framed in blue.
4. In the Sinteso Portal, select 'Disconnect'.
Prerequisites
●
Sinteso Tunnel is connected in the Sinteso Portal. See ''.
Connection properties
To access SintesoView, follow the steps listed in the 'ConnectingSintesoView'
section and set the following values:
●
Connection type: 'Connection to IP address'
●
Value: '127.0.0.1'
Connect SintesoView
 Enabling for viewing and / or operating the ↑ 'Station' with SintesoView is
granted.
 The PC is connected to the ↑ 'Site'.
1. Select the 'SintesoView' task card.
2. Select 'SintesoView' > 'Connect' from the menu bar.
 The selection window for the connection is displayed.
3. Select the connection and confirm with 'OK'.
 The 'Connect SintesoView' window opens.
Commissioning
Connecting SintesoView
symbol.
45 | 52
7