Standards And Directives Complied With; Hardening - Siemens Connect X300 Commissioning

2.4 Standards and directives complied with

2.5 Hardening

A6V12153163_en--_e
●
Inform others before testing alarm devices and anticipate that people might
react in panic.
●
Inform people about possible noise or fog that might occur.
●
Inform the corresponding alarm and fault receiving stations before testing the
remote transmission.
Modifications to the system design and the products
Modifications to the system and to individual products may lead to faults,
malfunctioning and safety risks. Written confirmation must be obtained from
Siemens and the corresponding safety bodies for modifications or additions.
Modules and spare parts
●
Components and spare parts must comply with the technical specifications
defined by Siemens. Only use products specified or recommended by
Siemens.
●
Only use fuses with the specified fuse characteristics.
●
Wrong battery types and improper battery changing lead to a risk of explosion.
Only use the same battery type or an equivalent battery type recommended by
Siemens.
●
Batteries must be disposed of in an environmentally friendly manner. Observe
national guidelines and regulations.
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
●
Personal injuries or damage to property caused by improper use and incorrect
application
●
Personal injuries or damage to property caused by disregarding safety
instructions in the documentation or on the product
●
Personal injury or damage to property caused by poor maintenance or lack of
maintenance
A list of the standards and directives complied with is available from your Siemens
contact.
Communication
The external DSL router connects the customer network to the Internet/cloud
server via the WAN port (X2P1) of the Connect X300 Gateway.
A physical cable is required to connect the WAN port to the DSL router. A WLAN
connection is not permitted.
The Connect X300 Gateway is connected directly to the Ethernet switch FN2012
via the LAN port (X1P1).
The Gateway contains an internal firewall to protect the FS zone. The FS
application configures the firewall. Only certified services can communicate with
the Gateway.
Communication is only possible from LAN to WAN. The firewall blocks incoming
communication from the WAN.
Only IPv4 is supported.
Standards and directives complied with
2
Safety
11 | 52