Connecting And Activating The Gigaset Sx686 Wimax - Siemens Gigaset SX686 WiMAX Quick Start Manual

Gigaset SX686 WiMAX / de-en / A31008-N919-R101-2-ZD43_22-10-2008 / qig_SX686_685.fm / 23.10.2008
W
This user guide assumes that installation of the outdoor antenna has been completed.

Connecting and activating the Gigaset SX686 WiMAX

Installation overview
1. If you use the outdoor antenna, have it installed by a radio and television technician.
Connect the antenna cable from outside to the Gigaset SX686 WiMAX.
2. Make sure that an Ethernet network card or a wireless Network adapter is installed
in the PCs you want to connect to the Gigaset SX686 WiMAX. The installation is de-
scribed in the user guides for these products.
3. Then make the necessary connections (PCs, phones) on the Gigaset SX686 WiMAX
and activate the device.
4. Before the PCs can communicate with the Gigaset SX686 WiMAX and with each oth-
er in a local network, you may have to adapt your network settings (see page 30).
5. With a wireless connection, you establish the link from the PC's wireless network
adapter to the Gigaset SX686 WiMAX. This is described in the user guide for the net-
work adapter. If the wireless network adapter provides WPS, you can establish the
connection with a simple click (see page 28).
6. Then configure the Gigaset SX686 WiMAX to activate the device's Internet access
(refer to the section entitled "Making the basic settings" on page 30). To do this you
will need the access data for your Internet service provider.
3.5 GHz versions should be used for the European Economic Area.
The following requirements apply:
All the external antennas used for this product must undergo a confor-
mity assessment procedure.
The 3.5 GHz antennas listed here meet the European requirements and
guarantee the functionality of the complete system.
During the conformity assessment procedure it was ensured that the SAR
limits set down in directive 99/519/EC are observed. Verification was per-
formed using EN 50385.
The outdoor antenna must be installed and put into service by a qualified
electrician.
The notes in the enclosed installation instructions must be followed
Quick Start Guide
25