Assa Abloy Corbin Russwin Access 700 ML20700 TCPWI1 Series Installation Instructions Manual page 8

ML20700 PWI/PIP Series Mortise Lock
4. Install Lock Body into Door:
a. Feed wires through hole on INSIDE of door while installing lock body (Fig. 4a).
b. Pull wires through hole while inserting lockbody (Fig. 4b).
DO NOT push wires back into cylinder hole.
IMPORTANT: Door must remain open during installation. Use door stop.
c. Install, but do not tighten two #12 x 1" combination screws through lock body (Fig. 4b).
Copyright © 2015 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
Fig. 4a
(2) #12 Comination Screws
8
Inside Face of Door
Fig. 4b