Assa Abloy Corbin Russwin Access 700 ML20700 TCPWI1 Series Installation Instructions Manual page 16

ML20700 PWI/PIP Series Mortise Lock
11. Installation of Connectors
CAUTION - Do not touch or allow debris to enter connector contacts.
Secure the following connectors to their respective terminals (Fig. 11a, b):
A. Secure the 10-pin lock body assembly connector.
*NOTE: Optional 2-pin external 9-24VDC power connector.
Wire Positioning:
Please follow these steps prior to installing
inside escutcheon to prevent any damage
caused by pinching wires:
B. Tuck excess cable into wire holes on inside of door
(Fig. 11c).
C. Finish securing mounting plate and reader to door by
fully tightening through-bolts on inside of door.
D. Secure the 24-pin card reader connector (Fig. 11c).
*For more detail, refer to section (5) 'Installation Wiring',
"A - Frame Harness Installation".
Copyright © 2015 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
D
A
Fig. 11b
Board-to-Board
Connector
16
Reader
(24-pin)
Fig. 11a
B
Tuck excess
cable here
Fig. 11c
9-24VDC
Power*
Lock
Body
(10-pin)